Honeywell ADEMCO VISTA-20P Programming Guide
Download Programming Guide for Honeywell ADEMCO VISTA-20P Security System [16 pages K5305-1PRV5 10/04 Rev.A 2004 pdf/zip]
Description
Programming Guide:
TO ENTER PROGRAMMING MODE (using an alpha keypad connected to the control):
A. POWER UP, then press [*] and [#] at the same time, within 50 seconds of powering up (this method must be used if *98 was used to exit program mode).
OR
B. Initially, key: Installer Code (4 + 1 + 1 + 2) plus 8 + 0 + 0.
PROGRAMMING MODE COMMANDS
SPECIAL MESSAGES
TABLE OF DEVICE ADDRESSES
PROGRAMMING FORM
SYSTEM STATUS REPORT CODES
RESTORE REPORT CODES
OUTPUT AND SYSTEM SETUP
DOWNLOAD INFORMATION
MISCELLANEOUS SYSTEM FIELDS
CONFIGURABLE ZONE TYPE OPTIONS
KEYPAD OPTIONS
CONFIGURABLE ZONE TYPES WORKSHEETS
ZONE PROGRAMMING MENU MODE
EXPERT ZONE PROGRAMMING MODE
WIRELESS KEY PROGRAMMING TEMPLATES
FUNCTION KEY PROGRAMMING
MENU MODE
ALPHA DESCRIPTOR PROGRAMMING
ALPHA VOCABULARY LIST (FOR ENTERING ZONE DESCRIPTORS)
SETTING SCHEDULES
SCHEDULES WORKSHEET
ZONE PROGRAMMING WORKSHEET
FUNCTION KEY WORKSHEET
OUTPUT RELAYS/POWERLINE CARRIER (X-10) DEVICES WORKSHEET
ZONE LISTS WORKSHEET
OUTPUT DEFINITIONS
SUMMARY OF CONNECTIONS
Helped you out?
Glad to heat that. It would be awesome if you could…
